Effective up to 100m (using 0.65mm wire) or 150m (using 0.8mm wire).
relies on simple, low-voltage wiring layouts. Review the diagram options below depending on your hardware environment. 1. Single Door Station to Handset (Standard 2-Wire)
Use a pencil to mark the two screw hole locations through the bracket slots. commax dp-ra01 installation manual
: Connect two wires from the outdoor door station (such as the DR-201D) to the corresponding terminals on the back of the DP-RA01.
Strip approximately 5mm to 7mm of insulation off the ends of the two wires. Effective up to 100m (using 0
This comprehensive installation manual covers technical specifications, wiring configurations, mounting steps, and troubleshooting procedures to ensure a successful setup. Technical Specifications
The Commax DP-RA01 is a reliable, analog audio door phone handset designed for secure residential and commercial communication. It operates as a duplex indoor unit, pairing seamlessly with Commax outdoor door stations to provide clear audio intercom capabilities and remote door-release functionality. Strip approximately 5mm to 7mm of insulation off
Comprehensive Installation Guide for the Commax DP-RA01 Door Phone
: Disconnect the power cable if the device will not be used for an extended period. Installation & Mounting
Here’s a professional write-up for the , suitable for a knowledge base, technical documentation site, or product support page.
Before beginning the installation, verify that all components are present and undamaged. What is in the Box Commax DP-RA01 Audio Handset Unit Wall Mounting Bracket Installation Screws and Anchors User Documentation Technical Specifications AC 110V / 220V (50/60 Hz), plug-in type