Firstchip Fc1178bc Firmware Hot | 2026 Update |
The operating system can detect the USB hardware interface but cannot read or write to the memory cells, showing an un-formattable partition.
Click on the or Config button (you may need to leave the password blank or input 123 ).
Click the Start button (often labeled 生產 or similar) to start the firmware flashing process.
A real-world example: one user reported that after attempting to fix their drive, they went from seeing their device in Disk Management but receiving a "not formatted" prompt to the drive becoming completely unusable—"显示没有媒体" (showing no media). firstchip fc1178bc firmware hot
A: Mass production can fix most software/firmware issues, but it cannot repair physical hardware damage such as broken solder joints, damaged NAND chips, or failed controller components.
Return to Settings, increase the ECC strength level, or force a lower target capacity limit.
: The standard tool for firmware resets and repairing "dead" drives. Versions like are specifically cited for the FC1178 series. The operating system can detect the USB hardware
A: Leave the password field empty — just click OK.
If the tool cannot see your USB drive, your controller might be bricked in a "deep sleep" state. You will need to manually put the chip into Test Mode . Carefully open the plastic casing of the USB drive, locate the FC1178BC chip, and use a sewing needle or pin to short-circuit two adjacent data pins on the memory chip while plugging it into the computer. This forces the controller to wake up and talk to the MpTool.
on the flash drive as it performs a low-level format and firmware reset. A real-world example: one user reported that after
Download and launch (a free USB information utility). Plug in your corrupted USB drive.
| Error Code | Possible Cause | Solution | |------------|----------------|----------| | Error 4 | Formatting failure | Try low-level formatting instead of advanced; ensure proper flash settings | | Error 6 | Flash ID mismatch | Double-check your flash ID; try a different MPTool version | | Error 3 | Failed during scanning | Your flash ID may not be supported; try an older/newer tool version | | Compatibility errors | Windows compatibility | Run in Windows XP compatibility mode | | Drive not detected | Driver issues | Try different USB port; reboot; run as Administrator |
Use a tool like to find the VID/PID and Controller Part Number . Standard VID/PID for FirstChip is often FFFF / 1201 . 2. Obtain the Correct MPTool
Monitor the active channel progress bar. The software will clear internal tracking allocations, run pattern checks across the NAND storage array, map bad blocks, and write fresh firmware data.
It sounds like you're dealing with a common issue where a USB drive using the controller is experiencing hardware failure or overheating, often due to corrupted firmware or a fake capacity setting .