Gunnebo Speedstile Fl Installation Manual 'link' Review

| Parameter | Specification | | :--- | :--- | | | 230V AC 50Hz or 115V AC 60Hz | | Power Consumption | 200W operating / 20W standby | | Throughput (max) | Up to 40 persons/minute (Prox/Smartcard) | | Mean Cycles Between Failures (MCBF) | 4–5 million cycles | | Mean Time To Repair (MTTR) | < 30 minutes | | Enclosure Protection | IP34 (indoor), IP?? (outdoor variants) | | Operating Temperature | +5°C to +40°C (indoor) / -10°C to +50°C (outdoor) | | Operating Humidity | 95% (non-condensing) | | Materials | 304 Grade Stainless Steel, 10mm–12mm Tempered Glass, Anodized Aluminum Lid | | Maximum Reader Size | Lid mount ≤ 9.8" × 3.3" × 1.2" |

: Run under-floor conduits (minimum 20mm diameter) at least 140mm below the finished floor level, ensuring they rise 50mm from the foundation into the cabinet. 2. Mechanical Installation SpeedStile FL

: Children must be supervised by an adult at all times in the vicinity of an active lane. When an adult escorts a child through the lane, the child must always proceed ahead of the adult. gunnebo speedstile fl installation manual

Manually test that the glass wings move freely without rubbing against the cabinet body. Switch on the main AC circuit breaker.

According to official technical documentation from Gunnebo and partners like Fichet Group : : Bolting Depth : A minimum of 70mm is required. Concrete Resistance : Minimum fckcube 30N/mm² . | Parameter | Specification | | :--- |

Connect the building’s fire relay to the dedicated emergency input. This circuit must be wired as Normally Closed (NC) so that an open circuit or loss of power automatically releases the glass wings for free egress. 5. Mounting the Glass Wings

Correct alignment is critical for the system's sensors and flap leaves to operate properly. Mechanical Installation SpeedStile FL : Children must be

Remove all tools, packing materials, and personnel from the lane walkway. Turn on the internal circuit breaker.