Hanmatek Dos1102 Manual Upd Instant

The Hanmatek DOS1102 is a 2-channel digital oscilloscope with a bandwidth of 100 MHz and a sampling rate of 1 GS/s. It features a 7-inch TFT LCD display and is designed for use in a variety of applications, including electronics, electrical engineering, and education.

By understanding the manual’s sections on triggering, automatic measurements, and the waveform generator, you can unlock the full potential of this versatile 2-in-1 tool.

Controls position, scaling, and coupling for each channel.

Before diving into the controls, it is important to understand what this hardware can handle: Bandwidth: hanmatek dos1102 manual

Frequency, Period, Rise Time, Fall Time, +Width, -Width, and Duty Cycle.

The top and bottom of the square wave should be completely flat, with crisp 90-degree corners. 4. Step-by-Step Operations Guide How to use the Autoset Feature

The DOS1102 includes an algebraic math engine. By pressing the button, you can add, subtract, multiply, or divide Channel 1 and Channel 2 in real-time. The Hanmatek DOS1102 is a 2-channel digital oscilloscope

According to official safety manuals for the DOS series , users must adhere to the following to prevent injury or equipment damage:

The trigger system stabilizes repeating waveforms and captures single-shot events.

Connect the probe to the terminal, a small metal pin usually near the bottom right, which outputs a known square wave signal. Use the AutoSet button to get a stable waveform. Then, use the provided adjustment tool (a small plastic screwdriver) to turn the trimmer screw on the probe until the square wave's corners are perfectly sharp and flat, without any rounding or overshoot. Controls position, scaling, and coupling for each channel

Connect the power supply to the back panel and turn on the unit. Probe Compensation: Connect the probe to Channel 1 (CH1).

Adjusts the timebase scale (zoom in or out horizontally to change the time value per grid square). The Trigger Control Zone

: Press the AUTOSET button. The scope will automatically configure the vertical, horizontal, and trigger settings for a stable view.

Set the Type to (horizontal lines) or Time (vertical lines).