Kincaid Radio Controlled Clock Instruction Manual |link| File

Your Kincaid clock contains a built-in miniature radio receiver. In North America, this receiver listens for a continuous low-frequency radio signal broadcast by the National Institute of Standards and Technology (NIST) radio station , located near Fort Collins, Colorado. Automatic Synchronization

Some Kincaid wall clocks use a more traditional manual setting method with a mechanical knob. If your clock has a metal or plastic knob on the back, follow these steps:

The clock is successfully catching a signal at night, but a wrong time zone or DST setting is causing it to recalculate the time incorrectly based on the new data. kincaid radio controlled clock instruction manual

: If the clock is off by exactly one or more hours, check that the correct is selected or that the Daylight Savings Time (DST) switch is in the correct position. Signal Interference

using the designated button (PST, MST, CST, EST). Your Kincaid clock contains a built-in miniature radio

Use a paperclip or a toothpick to gently press the button inside the hole for 2 seconds.

If you are outside the signal range or the clock fails to synchronize, you can set it manually. Radio Controlled Analog Clock Instructions If your clock has a metal or plastic

The radio receiver is inactive or turned off.

: Keep the clock at least 6 feet (2 meters) away from electronic appliances like TVs, computers, or microwaves that may disrupt the radio signal.

While radio-controlled clocks are designed to be automatic, knowing how to set the time manually is essential for troubleshooting or if you live in an area with a weak signal. Based on common clock models, these are the two most likely manual methods for a Kincaid clock.

If you live inside a building with a metal frame, concrete walls, or aluminum siding, the signal may struggle to penetrate. Position the clock as close to an exterior wall or window as possible.