This indicates a voltage overload. Turn off the power, wait 5 minutes, lubricate the deck (see below), and restart. If the error persists, the motor control board may require replacement. 4. Mandatory Routine Maintenance
Step onto the belt and use the arrows to adjust your pace. 🔧 Common Error Codes & Troubleshooting
The belt feels hot after 5 minutes of walking, or the motor sounds labored. sportcraft tx 25 treadmill user manual fixed
| Frequency | Task | | :--- | :--- | | Before each use | Check for loose bolts, debris under the belt, and ensure the safety key works. | | Every 100 hours | Lubricate the deck. Sportcraft explicitly recommends lubricating the deck after every 100 hours of use. | | As needed | Center and tighten the walking belt. |
Attach the safety key clip securely to your clothing waistband. Insert the safety key into the console. This indicates a voltage overload
Do not return to store. Call SportCraft customer service (check your manual for regional number) with model and serial number (located on the front crossbar sticker).
: Unplug the treadmill for 60 seconds to reset. Check the console ribbon cable for loose or pinched connections. Ensure the speed sensor and magnet near the flywheel are clean and properly aligned. Error "3" (Motor/Speed Sensor Fault) : | Frequency | Task | | :--- |
Turn the left rear roller bolt clockwise 1/2 turn.
Use the and Speed Down (-) buttons to adjust your pace.