To customize the hardware behavior, the V2000-c features specific jumper settings:
999999 (or sometimes 888888 depending on production batch).
For a : Connect the power supply +12V to the lock positive terminal. Connect the lock negative terminal to the V2000-C NC (Yellow) wire. Loop the V2000-C COM (White) wire back to the power supply GND. V2000-c Rfid Access Control User Manual
How long the relay stays activated.
If your V2000-c is connected to a networked access control system (such as Hanwha Techwin or AxxonSoft software), you can manage users via the software dashboard. To customize the hardware behavior, the V2000-c features
Warning: This wipes all memory clean. This cannot be undone. Enter programming mode. Press 2 . Enter 0000 . Press # . 6. Advanced Security and Relay Configurations Adjusting the Door Open Delay Time
Power on the unit while continuing to hold the button/jumper for 3 to 5 seconds. Loop the V2000-C COM (White) wire back to
This method creates a user that requires both a valid card and its corresponding 6-digit PIN to gain access.