Xinje Plc Usb Driver Install 2021 Online

After the driver is installed, you need to configure the XDPPro software to communicate with the PLC via USB.

Open your software (e.g., for XD/XL series or XCPPro for XC series). Go to Option > Software Serial Port Config . Select the correct COM port identified in Step 4.

After the driver and XINJEConfig tool are installed, the PLC must be in Xnet mode for USB communication. The XDPPro software handles this automatically when you follow the steps above to configure the communication port to ‘xnet’ and use the USB port. xinje plc usb driver install

To recap the golden rules:

If the software loses connection mid-transfer, open Device Manager, right-click your USB host controller, go to , and uncheck Allow the computer to turn off this device to save power . Additionally, try swapping to a USB 2.0 port instead of a blue USB 3.0 port, as older PLC chipsets occasionally conflict with newer USB standards. After the driver is installed, you need to

A: Firmware mismatch. Update the older PLC’s firmware via the XINJE update tool (requires serial connection first).

Upon reboot, press or F7 to select Disable driver signature enforcement . Select the correct COM port identified in Step 4

Before starting the installation process, ensure you have the necessary components ready to avoid connection failures.

Open Device Manager, right-click your USB controller/port, select Properties , go to the Power Management tab, and uncheck Allow the computer to turn off this device to save power . Hardware ID Missing / USB Device Not Recognized