When turned on, the controller runs a self-test. The PV window will show the measured temperature. The SV window will show the default target temperature. 3. Setting the Target Temperature
The XMTG-2000 is a universal input controller, meaning it supports multiple sensor types via internal configuration: K, J, E, S, T, B Thermal Resistors: Pt100, Cu50 2. Terminal Wiring Diagram xmtg-2000 temperature controller manual pdf
| Parameter | Value | | :--- | :--- | | Input Type | K, J, E, T, S, Pt100, Cu50 | | Accuracy | ±0.5% FS ±1 digit | | Output | Relay (3A/250V), SSR (12V/30mA), or Linear | | Power Supply | 110-240V AC / 24V DC optional | | Panel Size | 48 x 96 mm (DIN standard) | When turned on, the controller runs a self-test
Run the process. Check if the solid-state relay is stuck in the "closed" position. Check if the solid-state relay is stuck in
Fuzzy PID control or traditional On/Off hysteresis control.
| Output Type | Terminal Connection | Application | | ---------------------- | --------------------------- | ------------------------------------------------------------------------ | | Relay (3A/240V AC) | Terminals 8 & 9 (normally) | Direct connection to contactors (resistive loads) | | SSR Drive (0-12V DC) | Terminals 8 (+), 9 (-) | Drives external solid state relays for silent switching | | 4-20 mA / 1-5V Output | Terminals 8 & 9 (polarity) | Provides analog signal for proportional control of valves or actuators |
0–50°C, 35–85% RH (non-condensing)